Table with Custom Whisper Vinyl Rails Hole Saw to Cut Cup Holders January 25, 2006 Tim Conner 1 Comment I used a 2 and 7/8 inch hole saw to drill out the cup holders. Make sure you don’t cut at an angle. Placement is up to you. I put 8 cup holders at the table and centered them on what will be the exposed portion of the racetrack.
One thought on “Hole Saw to Cut Cup Holders”
Most cup holder inserts are for atleast a 8.6cm= 3 1/4 in wide hole up to a 4 hinch hole. Most of these cup holders can hold a 8.3 cm wide cup. So yes both your measurements and the authors measurements seem to be way off. Here is a referance link to a poker table cup holder with measurement specs in the photos. If anyone has a link to the metal insert let me know.